Swivel Chair Replacement Parts
Shown above, 4 leg dovetail hub and bottom plate with included installed hub liner for 1" threaded posts.
Some original factory installations used incorrect sized screws for the top and bottom plates. Our top or bottom screws are included with each purchase and correctly sized for either Hub or bottom Plate.

In addition, not all dovetails are created with exact same angles. If too loose, add and glue shims for a snug fit. If too tight, try to spread steel but still maintain a snug fit.

It is the bottom plate and screws which provide the strength needed to the legs. Many older 4 leg bases have broken screws which originally fastened the hub bottom plate. It is important to remove and replace those screws. Drill a 1 1/4" or preferably larger hole, and glue in an hardwood Hard Maple dowel rod. Purchase the Maple dowel rod first, then the drill bit to match the dowel rod. When glued and dry, drill a correct size pilot screwhole to fasten the bottom plate. Warning, a screw sized dowel pin is the wrong thing to use for a repair.

What is a Dovetail?
This is a photo of a Dovetail
A leg end slides into the provided angled metal plates on the hub and is captured. Wood shapes called Dovetails, are machined to precise angles as to hold tightly in the provided space thus giving much strength. The entire chair and user weight is carried by the dovetails and bottom steel plate.
Be sure to replace broken bottom plate screws.
#K8694 4 Leg hub with bottom plate. Includes all screws
$81.50
Add To Cart
#K8896 5 Leg hub with bottom plate. Includes all screws

$89.40

Phone
only
#94-4 leg additional bottom plate
$12.45
Add To Cart
#97-5 leg additional bottom plate

$12.80

Add To Cart
4 Leg Design #K8694
Site Map - Privacy and Security - Terms and Information - Contact

Office swivel chair 4 and 5 leg base hubs and bottom plates

5 Leg Design #K8896

Office chair
Bells and Washers

#74 1 5/8"x 2 1/4" dia Black $19.40
#75 3 7/8" diameter
Looks like #76 but is smaller diameter
Black $20.75
$13.65
#76 4 3/8" diameter Black $27.35
Select a Bell:

If the threaded Post is not already loose (do not loosen), then only the #83B can be installed. The #83B thrust washer must first be sawn or knife cut to install. The cut mark line is shown directly above the #83B number in the shown photo.

Bells and washers are intended for 1" diameter

Select a Washer: